Dominator Remote Coding Instructions

Dominator Remote Coding Instructions

1. Power Reset:
   • Disconnect the power supply to the system.
   • Reconnect the power supply.
2. Enter Programming Mode:
   • Press and release the program button two times.
   • Observe: The four LEDs will flash on and off two times.
3. LED Status Check:
   • LED #1:
     • If it is flashing or illuminated, it indicates that a code is already stored in this location.
     • Press the program button once again.
4. Check Next LED:
   • LED #2:
     • If LED #2 is illuminated, it means the location is not available.
     • Press the program button again to check LED #3.
5. Find an Available LED:
   • LED #3:
     • When a flashing LED is found (either LED #2 or LED #3), press and hold the new transmitter button.
     • Wait until the LED stops flashing and becomes solid.
6. Completion:
   • Your remote has now been successfully programmed!

Note:

Ensure that you have the correct transmitter ready before starting the programming process. If you encounter any issues, refer to the product manual or contact customer support for assistance.

This step-by-step guide will help you code your Dominator remote efficiently!